Back panel done for the time being

So this past Saturday, I got down and finshed up the rear panel. There were a few little things that needed some polyester glaze so a skim coat was applied and sanded down. Sprayed the rear panel with high build primer and for the most part the panel came out alright. there's a little ding i missed right above the right tailight, but I'll come back to that when I block sand the primer.

Closer shot of the rear panel

One more..

Oh, and so I started to dig around on the passenger side 1/4 panel. This is going to be fun. I got my angle grinder out with a 36 grit disk to cut into the old filler. So I sit there and grind a bit, grind a bit more....where's the metal? grind a bit more...and finally i see the metal. I have to say, the filler work in this lower section is about 1/2' thick at the bottom. Man I gotta love the last owner who decided to fill rather than fix.

Looks like there's about 3 layers of filler!

Class is out for the next two weeks, so since I now have some engine bay measurements and my new engine, along with a good used front subframe, I think I'll be mocking up the engine in the subframe and making engine mounts for the 4AG.