More Wiring

So I got to wiring up the chassis harness over the weekend. started out by clipping the wires that were of no use. Then ran the tail section wires to the trunk. That will be finished up later when I put on the tailights. So I ran the wires to the front section next. Since I got rid of the harness plugs that go through the firewall, I ran them along the inner fender well.
Wires ran up along the inner fender, down to the headlamps, then using the factory grommets on the front side of the fender, ran the passenger side wires to there.
Here's a shot of the right side inner fender. Left side looks similar, but w/o the coil, ignitor and map sensor. You can see the HID Ballasts mounted up along with the HID relay.
Fuse panel is mounted on the driverside of the car, as the ECU is mounted on the passenger side. There's just too many wires!