Interiors and such

So I started working out some of the inteior in the last few weeks, 1st started off by making/modifying the seat mounts that I had for the pair of free seats I took from my younger brother. Tabs were 1st made.
Cleaned up the old rails

Started welding the tabs onto the rails.

Almost there, didn't think to take pics of the finshed product along with the seats mounted in the car, will have to do that soon.

Next started working on the rear deck panel. my old one was crumbled and had holes in it, so a new one was made with a bit of wood.

Andy here cleaning up the wood that was wrapped in a bit of foam

Laid out on the table to spray the adhesive on both panel and black vynil

Putting Andy to work fitting it all up!

Next thing we're working on was the door panels. They'll look somewhat orginal, with the centers but a little different. We'll see how they turn out...

cut the outer sections out of interior cardboard type material, was then traced out on the vynil to see how everything was going to fit.

Masked off the areas where the adhesive shouldn't be...

Once the boards were covered in foam and trimmed, more adhesive was laid out on the foam to cover with the vynil.

Board covered in foam covered in vynil

This will all be assembled later on the door panel we made. it's a bit different and so far it looks decent, will have to put it in the car and see how it all ties in.

Ran out of adhesive, so will have to go back to the interior shop for some more, along with more of that cardboard stuff to make the rear panels. Also just got a pair of 16P calipers, so will have to tear those down and rebuild them.

Lots to do with lots of time, but so little funds!